As a Senior MDE Engineer, you will be responsible for defining and implementing DFMA good practices to the design of our product. You will be a key member of the development team and will be the main interface between the Hardware and Product Design Engineering teams with local and Offshore Operations teams within Lab126 and our OEM partners. In this role, you will:
·
· Work with design engineering to identify and escalate manufacturing challenges by enforcing DFM, DFA and DFS principles
·
· Investigate and introduce new manufacturing technology and methodology to enhance product quality and production efficiency
·
· Develop manufacturing process at the ODM, including defining fixture requirements, critical dimensions on parts and critical requirements in assembly
·
· Drive all factory-related operational issues related to final assembly processes during pre-production builds; ensure effective closure to enable operational success of the new product introduction cycle, and put products into mass production
·
· Identify and develop assembly jig and fixture for new products
·
· Work within Operations, Hardware, and Product Design engineering departments to implement and optimize manufacturing 1st pass yields and efficiency from prototype through product ramp
·
· Bridge the gap from OEM to Lab126 by supporting development builds and production
·
· Support cost reduction and sustaining activities